|
OCD Rewinder
Posted 10 July 2019 - 04:59 PM
Some years ago, someone here made me a freaking dandy armature clamp, and for the life of me I can't remember who it was. Anyway, I need another clamp made for a bunch of smaller diameter arms and I've been ruining a clamp I had by over-tightening it. Sooo...if you're the guy who made me the clamp, or if you're a machinist who can bang one out, please PM me. I can PayPal or do it for trade (arms/motor). The clamp can be made from aluminum or brass. 1/2" bar stock is fine.
TIA
Mid-Pack Racer
Posted 10 July 2019 - 05:21 PM
Builder
Posted 10 July 2019 - 06:01 PM
My best guess is, it was Rick Bennardo, but not sure
Paul Wolcott
Checkered Flag in Hand
Posted 10 July 2019 - 06:31 PM
Pretty sure it was Rick...
Don
Don Weaver
A slot car racer who never grew up!
The supply of government exceeds demand.
L.H. Lapham
If the brain-eating amoeba invades Washington
it will starve to death...
OCD Rewinder
Posted 10 July 2019 - 06:48 PM
It was not Rick, that much I am sure of.
Age scrubs away speed!
Posted 10 July 2019 - 08:46 PM
May 4, 2009 ... Page 15 of 143 - Arm winding #1 - posted in Motors & Motor ... having Rick make me a 26D clamp for my RGEO crank winder when yours came ...
Don't you have a brass arm clamp made by someone else, used on your wooden winder? I found a photo of it, but no verbiage as to who made it.
OCD Rewinder
Posted 11 July 2019 - 04:19 AM
Hi Bill,
Yes, I remember all that, and the person who made me that clamp I mentioned in post #1 wasn't Rick. The brass arm clamps I have were given to me by a Blogger many years ago, and he never mentioned who made them. **However, the guy who made the clamp DID PM me, so I think I'm good! Thanks!
