Month View
Week View
Day View
Tuesday Night Racing at TR MotorPlex.
$100 Wing and GT1 Flexi. $5 entry per class. See rules here.
Practice begins at 5:00 PM, Racing starts at 7 PM.
T/R Motorplex
43 S. Main Street
Miamisburg, OH 45342
(937) 384-RACE (7223)
Events for April 04, 2011
in Nat'l/Reg'l
● SRR Tuesday Night Flexi NASCAR, Columbia, NJ
By
7D7 Hobbies
Permalink
This racing event takes place every other Tuesday: 4/05/2011, 4/19/2011.
The track opens for practice at 5:30 PM and racing starts at 7:30 PM.
Flexi-NASCAR Rules:
Chassis:
Stamped steel, 4" wheelbase "Flexi-car" type.
Bracing of rear axle uprights is allowed.
Soldering or gluing of rear axle bushings and front axle into the chassis is allowed.
Pin tubes may be added instead of body clips.
Excluded are any chassis with open motor boxes, i.e. JK Cheetah 11.
Motor:
Parma #501 "Deathstar" sealed motor. Seal must be intact, with NO modifications allowed.
Brushes and springs can be replaced but must be original type.
Soldering in the can bushing is not allowed.
Gears:
48 pitch, 9 tooth straight pinion.
Axles:
1/8" rear solid steel axle, 1/16" front axle.
Wheels / Tires:
1/2" or 5/8" front wheels, O-rings must be installed.
Any commercially available rear tires made of black rubber are allowed, "No silicone coatings".
Body:
Any commercially available 4" wheelbase NASCAR style body.
"Slammed" or bodies with excessively high rear spoilers are not allowed.
Bodies must have a minimum of 1/16" clearance from bumper to valance.
Front wheel openings must be clear or cut out to show the front wheels.
Interiors are not required.
Although it is not mandatory, we encourage you to make the cars look like "NASCAR" type cars.
Clearance / Width:
Clearance shall be a minimum of 1/16" (.063") under entire car, including spur gear, as measured on a flat tech block.
Width shall be no more than 3-1/4".
Wheels may not be offset relative to chassis.
Tech Points:
Clearance, width, motor, front wheel O-rings and body.
No "glue" (tire traction additive) is allowed... not on the track and not on your tires.
If it's not mentioned, it's not legal!
Slot Racing Revival
410 State Route 94
Columbia, NJ 07832
(908) 496-4422
The track opens for practice at 5:30 PM and racing starts at 7:30 PM.
Flexi-NASCAR Rules:
Chassis:
Stamped steel, 4" wheelbase "Flexi-car" type.
Bracing of rear axle uprights is allowed.
Soldering or gluing of rear axle bushings and front axle into the chassis is allowed.
Pin tubes may be added instead of body clips.
Excluded are any chassis with open motor boxes, i.e. JK Cheetah 11.
Motor:
Parma #501 "Deathstar" sealed motor. Seal must be intact, with NO modifications allowed.
Brushes and springs can be replaced but must be original type.
Soldering in the can bushing is not allowed.
Gears:
48 pitch, 9 tooth straight pinion.
Axles:
1/8" rear solid steel axle, 1/16" front axle.
Wheels / Tires:
1/2" or 5/8" front wheels, O-rings must be installed.
Any commercially available rear tires made of black rubber are allowed, "No silicone coatings".
Body:
Any commercially available 4" wheelbase NASCAR style body.
"Slammed" or bodies with excessively high rear spoilers are not allowed.
Bodies must have a minimum of 1/16" clearance from bumper to valance.
Front wheel openings must be clear or cut out to show the front wheels.
Interiors are not required.
Although it is not mandatory, we encourage you to make the cars look like "NASCAR" type cars.
Clearance / Width:
Clearance shall be a minimum of 1/16" (.063") under entire car, including spur gear, as measured on a flat tech block.
Width shall be no more than 3-1/4".
Wheels may not be offset relative to chassis.
Tech Points:
Clearance, width, motor, front wheel O-rings and body.
No "glue" (tire traction additive) is allowed... not on the track and not on your tires.
If it's not mentioned, it's not legal!
Slot Racing Revival
410 State Route 94
Columbia, NJ 07832
(908) 496-4422
4
April 2011
April 2011
Celebrating Today
(35)
FbodyGodfather
(56)
Mike Farrell
