29 replies to this topic

[Martin]

I think I have the start of a motor for this project, if interested check out link below.

 

http://slotblog.net/...e-2#entry859085

 

[Mark Onofri]

Wishful thinking on my part and also, a subtle hint that you should repo some.
As I said, the fronts your using are correct. I,personally would like something closer to the real cars big n little arrangement

[Martin]

Mark, it does not look like it in the pic as the camera is closer to the fronts the rears are bigger in diameter ( I did not take much off the front for that to press into the I.D of the rears. 

But do you like the motor can ? follow this link if you have time.http://slotblog.net/...e-2#entry859085

[Mark Onofri]

I have a smaller one somewhere, I missed the bid for a set of four (2front,2rear). The with is~=9/16".
"seems to me I've seen it before " well, Jeff Beck would have said something like that.

Attached Images

• 
• 

[Martin]

Mark, that is a Testors wheel. 6 hole (my fronts are 5 hole) and I wanted set screw not 5/40 threaded.

 

I did use them on my MDC Bat car to match the Riggen 5 hole fronts.